5
WFT07 instructions of the code match
1.Remote control device settings
●
unction instruction:
The remote control for the 2.4G spread spectrum,
frequency hopping systems, have high anti-
interference. The remote control has unique
address identification code information, Before
use the remote control,pls match the code with the
2.4Ghz receiver.
●
Settings
Into the "Advanced Settings" menu item under the
"Preferences" . Press confirm button
to enter the
"code" interface in the "Advanced Settings" . As
above.
The specific settings as follows:
1. The
first use the button to select on the code, the code
process needs within a short distance. 2.4G
module system in the closed state is not available,
please refer to “
Once Code
Coaching / Simulation”
successfully will return to the menu. Also can press
"exit”button to return.
Warning
When using this function, please ensure that no other remote control operating!
2.Receiver Settings
Remote control device into this interface:
Then going receiver settings: receiver hold "SET" button until the STATUS indicator light flashes slowly, waiting for
the transmitter of the code instructions.
(WFR07S/WFRO9S operating are same)
LED
Slow flashing
After the success of the code ,the LED light is off, you can normally using.
Note:
The code required in a short distance.
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE