INSTRUCTION
HELICOPTER
(2)Move curve point operations are as follows
When you want to adjust the data of curve point, such as you
have increased one curve point in the 0.0% position, if you want to
make the increased point to move to +5.5% position, please select
the 0.0% this curve point, that means in the throttle curve settings
menu make the cursor in 0.0% position, → Press confirmation
button to make the cursor blink → Press the right button to move
the right of the data in the cursor blinking area to transfer to +5.5%
→ confirmation
Of course, not just in one place there are two curves of points
should be adjusted then moving curve point, whatever you want to
move the curve point can be adjusted in accordance with this
method. Another point on the operation for reduction of curve point
is to use(-)key stead of (+) key, press OK button, it is simple
。
Note:
Here is the explanation to the two curves of points in a
position, when the two curves points in one position, the eyes can't
see, but only when the cursor stops blinking, when
you press the right or left button, actually,
the numbel below the
cursor haven't any changes, it means the broken line of the curve
point also haven't any changes, that means there are two curve
points in the position now.
The
picture
can
show
there
are
ten
curve
points
.
66
