Model # ODUS-CGTP
Please call for replacement parts or assistance:
1-866-942-5362
Whalen Furniture Mfg., Inc.
Page 17 Factory No. 16015
Assembly Instructions
37.
Extend the Sliding Tracks on the unit all the way forward (including ball bearing cart). Then align the Slide
Runners on the assembled drawer with the Slide Tracks and push the drawer carefully inside until it stops.
NOTE
: If the drawer does not go in smoothly, please take it out and repeat the step. If you need to
remove the drawer, please pull the drawer all the way out, then simultaneously push the plastic release
lever of the ball bearing slide up on one side and down on the other side, and then pull it completely out.
38.
Position the assembled unit in the desired location against a wall. Now, follow the instructions printed on the
plastic bag containing the Tipping Restraint Hardware to mount the tip-over restraint to the unit and the wall.
NOTE: Young children can be seriously injured by tipping furniture. You must install the Tipping Restraint
Hardware with the unit to prevent any accidents or damage to the unit. The tipping restraint is intended only as a
deterrent, they are not a substitute for proper adult supervision. The tipping restraint is not an earthquake restraint.
If you wish to add the extra security of earthquake restraints, they must be purchased and installed separately.
Tools required: Phillips screwdriver, Power Drill, 3/8” Drill Bit and Rubber Mallet.
