6
DRAWER INSTALLATION
If you need to remove the drawers with ball bearing slides from the unit, please follow the steps
below to prevent any damage to the slides or the drawers.
1.
If you need to remove the drawer, please pull the drawer all the way out, then simultaneously
pushes the plastic release lever of the ball bearing slide up on one side and down on the other
side, and then pull the drawer completely out.
2.
To place the drawer back, simply push the ball bearing cart all the way to the end of the slides
(in both sides) and align the slide runners on the drawer with the slide tracks on the unit and
push it carefully inside until it stops.
NOTE:
If the drawer does not go in smoothly, please take it out and repeat the step.
Release lever
FRONT
Ball bearing cart
Ball bearing cart
FRONT
