13
Assembly Instructions
Tools required: Phillips screwdriver, Power Drill, 3/8” Drill Bit and Rubber Mallet.
29.
Position the assembled TV console at the desired location against a wall. If necessary, adjust the
pre-attached Floor Levelers on the bottom of the Side Frames (N and O) to level the unit. Now, follow
the instructions printed on the plastic bag containing the Tipping Restraint Hardware to attach the
tip-over restraint between the console and the wall.
NOTE: Young children can be seriously injured by tipping furniture. You must install the Tipping
Restraint Hardware with the unit to prevent the unit from tipping, causing any accidents or damage. The
tipping restraint is intended only as a deterrent, they are not a substitute for proper adult supervision.
The tipping restraint is not an earthquake restraint. If you wish to add the extra security of earthquake
restraints, they must be purchased and installed separately.
30.
The console is now ready for use. Be sure to position your Flat Panel TV in the center of the console.
