Section 4 - Electrical System
320 Outrage-Owner’s Manual
The 320 Outrage is equipped with dual outboard en-
gines for propulsion.
The 320 Outrage engines starting procedure is as fol-
lows:
• Make certain that the lower units of the engines
are in the water.
• Insert the keys into Ignition switches, (located
on the aft wall of the console cabin).
• Turn keys clockwise.
Note: Turning the keyswitches on from this loca-
tion will not start the engines.
• There are switches on the helm instrument panel
marked “Port Ignition” & “Starboard Ignition”.
The upper section of the switches will need to
be pushed forward.
• There is a momentary switch located to the right
of the ignition switch marked “Start”.
Pressing these switches will start the engine the
switch has been designated for.
• Shutting down the engines requires just pushing
lower portion of the “Port Ignition” & “Starboard
Ignition” switches forward.
Engine Starting Procedure
The gear shift /throttle control will not allow engine start-
ing if the control levers are in any other position than
NEUTRAL. Check the levers for neutral position be-
fore starting the engines.
NOTICE
Profile view of the Port/Starboard Ignition button.
Push here to
START engine
Push here to
STOP engine
Engine Start Switches
on Instrument Panel
Dual Engine Key Switch Panel
!
HORN
PORT
START
PORT
IGNITION
STBD
IGNITION
STBD
START
SWITCHED BREAKERS
HORN
NAV/ANCH
TRIM TABS
STEREO
HELM 12V
RECEPTACLE
IGNITION
PORT MASTER
STARBOARD MASTER
IGNITION
29