24
5.2.3. VCR OUT
This allows you to select CVBS or S-Video output from the VCR SCART socket.The receiver can
output SVideo and CVBS signal from the VCR SCART on the rear panel.
5.2.4. HDMI RESOLUTION
This receiver can give HDMI output in 3 different resolutions: 576p, 720p and 1080i from the HDMI
connector on the rear panel. In order to get best picture quality, please check the HDMI resolutions
supported by your TV set and select the most appropriate one from this menu. Note that only stored
channels can be watched over HDMI, not VCR input. This function duplicates the selection made at
the time of first installation.
5.2.5. FAVOURITE MODE
This function enables or disables the 5 favourite channel list mode by pressing “
3
/
4
” buttons and
press OK . IF a favourites list exists it will switch to the list number selected. If there is no favourite
listing, a warning message is displayed.
5.2.6. CHANNEL LIST
Use “
5
/
6
” buttons to go to Channel List option. Use “
3
/
4
”buttons to toggle Channel List Mode. If
you select “TV Only” you navigate through only TV channels, if you select ”Radio Only” you navigate
through only radio channels, if you select ”Text Only” you navigate through only text channels with the
PR+/PR- buttons. If you choose “Show All” all, channels can be navigated with the PR+/PR- buttons.
To save the recent changes and exit; press the MENU button.
5.2.7. SCAN ENCRYPTED CHANNELS
Use “
▲
/
▼
” buttons to go to the Scan Encrypted Channels option. Use “
◄
/
►
” buttons to toggle
YES or NO the searching for encrypted channels.
5.2.8. RECEIVER UPGRADE - OAD
Over Air Download (OAD):
To ensure that
your STB always has the most up todate
information. Please ensure that after use it
is set to its standby mode. The STB
automatically powers up at 3.00 A.M. each
day and searches for any new information
which may be broadcast and will download
this to your receiver automatically. This
operation will normally take approximately
30 minutes. If you have an important
recording to make at 3.00 A.M. which must
not have a 30 minutes interrupt then you
can disable the auto OAD search by
performing the following:
Ø
Press Menu button and using the
“
5
/
6
” buttons to choose Setup
and press the OK button.
Ø
Highlight Configuration menu with “
5
/
6
” keys and pres OK.
Ø
Use “
5
/
6
” buttons to choose "RECEIVER UPGRADE" and press OK button.
Ø
Using the left / right button change “Automatic scanning” from Enabled to Disabled.
Ø
Highlight “Scan for upgrade” menu with “
5
/
6
” keys and pres OK to commence upgrade.
Do not forget to re enable the automatic OAD function after you have made your recording by
repeating the above instructions but this time selecting ENABLE.
