4000x Series Digital Clock
Operating and Installation Instructions
SC 04
SC 04
4200 display - Minutes only
4010 display - Minutes, seconds only.
Countdown
dura on seconds.
Countdown
duration
00
00 01 00
Set seconds, range 0-59.
Countdown
dura on minutes.
00 01
00 01 00
Set minutes, range 0-59.
Countdown
dura on hours.
00 01
00 01 00
Set hours, range 0-98.
Exit to me
display.
10 - External interface setup
The external interface of the 4000x series clocks can be used for connec on of a 406 temperature (supplied
separately) or to provide a Local Master synchronisa on output..
Fu Et
External Interface Setup
Function
Display Type
Description
'Up' button
function
hh:mm
(4200)
hh:mm:ss
(4010)
External Interface O ff
Et O ff
External interface disabled (required for use with
external stopwatch switches).
Exit to me
display
Ta lt
Et Ta lt
Display alterna ng me and temperature display. See
406 documenta on for further se ngs.
Exit to me
display
Tc nt
Et Tc nt
Display con nuous temperature display. See 406
documenta on for further se ngs.
Exit to me
display
Lo cl
Et Lo cl
Enable Local Master synchronisa on output (can
provide synchronisa on to a maximum 5 4000E units).
See Local Master documenta on for further details.
Exit to me
display
11 - System setup
The system setup menu contains general setup op ons for the 4000x series digital clock displays as follows.
Fu St
System Setup
Function
Display Type
Description
'Up' button
function
hh:mm
(4200)
hh:mm:ss
(4010)
Display Brightness Br A
Br A
Display brightness can be automa cally set (A) or set to
one of seven fixed levels (1-7)
Select me
format
Time Format
24 hr
24 hr
Display me in either 24 hour (military) or 12 hour
format.
Display F/W
version
Firmware version 01 dd
01 dd
Firmware version clock is running.
Display B/L
version
Bootloader version 00 62
00 62
Bootloader version clock is running.
Factory mode.
Factory mode
Eg 00
Eg 00
Factory mode, not user accessible
Exit to me
display.
12 - Clock Status Display
The synchronisa on status of the 4000x series digital clocks is confirmed by the status of the Colon LEDs. If
the Colon LEDs are flashing, the unit is unsynchronised. When the clock successfully synchronises to the
selected me source, the Colon LEDs remain sta cally illuminated.
From the me display, the ‘+’ bu on can be used to scroll through the following informa on:
Time > Date > Brightness > Network mode > IP address > Subnet mask > Gateway address > MAC address
16
Issue 2.2
