Quick Start – 4
WheatNet-IP
/ Apr 2009
Surface Setup
If you have an Mix Engine Blade, it can be used with a Wheatstone E-Series surface
to provide mixing capability. In order to be used in a BLADE system, the surface must
first be properly configured.
Network Settings
When the E-Series surface is powered up the first time it will display a dialog box
stating that no network file was found (See Figure 1).
To configure the network settings for the E-Series surface select “YES” from the
dialog box. The surface will now display the Options Tab (See Figure 2). Here you will
set the BLADE ID and IP address of the Engine to which the surface will connect, along
with the Surface IP Address, Subnet Mask, and Gateway. If Automatic mode is
selected, enter the BLADE ID of the Mix Engine Blade to be associated with the surface
and remaining settings are configured for you. You can manually enter this information
by turning off Automatic mode and using the numbered keypad on the screen. Pressing
NEXT will advance to the next field. When done simply press APPLY to finalize these
settings and the surface will request a reboot (See Figure 3).
Figure 1