A P P E N D I C E S
page A – 19
WheatNet-IP
/ Apr 2009
Checking and Saving the Switch Configuration
When you are done, check the switch configuration by typing the following command
from the command prompt.
show running-config
show running-config
show running-config
show running-config
show running-config
Once you are sure you have the correct configuration you need to save it. You can save
the configuration by typing one of the following commands
copy running-config startup-config
copy running-config startup-config
copy running-config startup-config
copy running-config startup-config
copy running-config startup-config
or
write memory
write memory
write memory
write memory
write memory
Below is a diagram that shows you what a typical configuration might look like.
WheatNet-IP
/ Dec 2009
page A – 16.3