A P P E N D I C E S
page A – 23
WheatNet-IP
/ Apr 2009
To setup ports on the switch you must also be in the Global Configuration mode.
To enter the configuration mode once again type “Config T” and press enter.
Enter the following commands
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
switchport mode access
switchport mode access
switchport mode access
switchport mode access
switchport mode access
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
speed 1000
speed 1000
speed 1000
speed 1000
speed 1000
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
e n d
e n d
e n d
e n d
e n d
Ports on the 3750G and 3560G can be configured individually or in a “Range.” If
range is desired type Interface range gig1/0/1 - 24 using the desire number of ports.
Configuring Gigabit Ports Connecting to Wheatnet IP Control
Surfaces, GP Panels, and XY Controllers
Enter the following commands
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
switchport mode access
switchport mode access
switchport mode access
switchport mode access
switchport mode access
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
speed 100
speed 100
speed 100
speed 100
speed 100
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
spanning-tree portfast
e n d
e n d
e n d
e n d
e n d
Ports on the 3750G/3560G can be configured individually or in a “Range.” If range
is desired type Interface range gig0/1 - 24 using the desired number of ports.
Configuring Ports for Linking to Other Network Switches
Trunk mode is used when connecting another switch to the port.
To set a specified port to trunk mode when connecting to another network switch
the port needs to be set for trunk mode. To setup Gigabit ports on the switch you must
also be in the Global Configuration mode. To enter the configuration mode once again
type “Config T” and press enter.
Enter the following commands.
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
Interface gig 0/x (X=the Ethernet port being configured)
switchport trunk encapsulation dot1q
switchport trunk encapsulation dot1q
switchport trunk encapsulation dot1q
switchport trunk encapsulation dot1q
switchport trunk encapsulation dot1q
switchport mode trunk
switchport mode trunk
switchport mode trunk
switchport mode trunk
switchport mode trunk
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
switchport nonegotiate
e n d
e n d
e n d
e n d
e n d
WheatNet-IP
/ Feb 2010
page A – 16.7