page A – 92
WheatNet-IP
/ Mar 2014
A P P E N D I C E S
Once PC-XY establishes a connection with the specified Blade, you
will see that the LINKED “LED” will turn bright green. Source and
Destination signal names will also be available in the drop down lists.
Note that the Visibility controls, explained later, determine exactly
which Source and Destination signal names are available to this
particular installation of PC-XY.
Using Source / Destination Windows
These windows allow access to any number of sources and destinations.
• Use the
SOURCE drop down
list to select the audio input
you would like to route.
• Select a
DESTINATION
from its drop down list.
• Press “
TAKE” to complete
the route.
• Customize lists with
Visibility settings.
Logging Out
When you have completed the setup of PC-XY you can Log Out. When you log out,
PC-XY continues to function however users can not edit any of the settings without the
Log In password.
Visibilities
The Set Visibilities
form allows the engineer to configure PC-XY so the end user “sees”
a limited set of Source, Destination, and Salvo signals. This is where you limit what shows
up in the drop down Source and Destination lists on PC-XY’s front panel. This function
is useful when
you wish to give
non-technical
users Source
select control
of a very lim-
ited number
of sources and
usually control
of only a single
destination –
like a set of
PC speakers
or the input
to a recording
device.
