5
FireLite
Furnace Operations Manual
Version 1.00.7 – 1/05
Installing the Vacuum Pump
• If you have a Whip Mix supplied vacuum pump, simply
attach the pump power cord into the international
standard outlet on the furnace marked
Vacuum
Pump
, as seen in Figure 6.
• If you do not have a Whip Mix supplied vacuum pump,
plug the vacuum pump’s power cord into the outlet end
of the short power cord supplied with the furnace.
• Attach the other end of this short power cord to the
international standard outlet on the rear of the furnace
marked
Vacuum Pump
.
• Attach a 1/4 inch vacuum rated hose from the vacuum
pump to the brass fitting marked
Vacuum Pump
at the
rear of the furnace.
Note:
The vacuum pump will only run continuously.
Whenever a program requires vacuum, the pump will
run continuously until vacuum is no longer required.
Figure 6
Mounting the Keyboard
When you unpack your FireLite furnace, the keyboard will be
located in the accessory box.
1. Remove keyboard from accessory box and loosen the
thumbscrews.
2. Flip the keyboard around to the proper orientation as
seen in Figure 3. One lock-washer goes on the outside
of the brackets on each side and one lock-washer sits
between the keyboard and the inside of the bracket.
Adjust the keyboard to the desired position and tighten
the set screw.
3. To complete the keyboard installation, simply plug the
keyboard cable into the back of the keyboard until you
hear a click as seen in Figures 4 and 5.
Figure 3
Figure 5
Figure 4
