10
Pro 200 Series
Furnace Operations Manual
Using the Furnace
After the furnace has completed the self-test at power up,
the Firmware Version appears on the screen, then the
Display prompts the entry of a Program number for firing.
Press the
Menu
button to bring up the
Main Menu
, then
Select the
Special Functions
menu item and proceed with
the initial setup of essential default values for functions like:
• Idle Temperature
• Vacuum Threshold Level for Intermittent Vacuum mode
• Temperature Display Units (C or F)
• Program Start Delay Time (Default is none)
• Night Mode Temperature
• Constant Vacuum Pump
(Default is “NO” for Intermittent Vacuum)
• Sound Volume Adjust
• Capital Letter Display (Default is mixed upper and
lower case display)
• Displayed Language
NOTE: IT IS VERY IMPORTANT TO SET UP THE OPERATING
FEATURES OF THE FURNACE BEFORE YOU ATTEMPT TO
PROGRAM THE FURNACE OR RUN PROGRAMS. FOR BEST
RESULTS IN LEARNING TO USE YOUR NEW FURNACE,
USE THE FOLLOWING STEPS, IN THIS ORDER:
1. Set up the operating features of the furnace
by reading and following the instructions in
Chapter 2 — Special Functions
. This is
VERY
IMPORTANT
because these operating features
will affect how you enter and run programs.
2. Learn to program the furnace by reading
Chapter 3 — Change Program.
Enter a few
of your own programs.
3. Read
Chapter 4 — Run Program
to understand
how to run programs and what features are
available while running a program.
Summary of Contents for Pro 200 Series
Page 32: ...IT 11522 10 13 ...