2-9
REASSEMBLY NOTES:
• Before you reassemble the control assem-
bly, make sure that the slide switches oper-
ate properly, and that the indicator light is in
line with the red lens, before securing the
housing sections.
• Install the spring in the control assembly as
shown below. Keep the short end of the
spring on top of the boss (molded on the
side of the switch panel). Also keep the long
end of the spring against the inside of the
frame, and the pin in the grooved track.
Blac
k
Blac
k
Or
ange
Blue
White
White
2 Blac
k
2 Blac
k
2 White
9.
Remove the wires from the screw termi-
nals on the two terminal blocks, and re-
move the control board from the housing.
NOTE: Make sure to connect the wires to
the same terminal locations on the new
board (see the wiring illustration).
Place Short End
Of Spring On Top
Of Boss Here
Keep Long End Of
Spring Against
Inside Of Frame
Position Pin
In Track Here
Control Board
Terminal Block 1
Terminal Block 2
Control Board
Summary of Contents for 4317332
Page 1: ...TECHNICAL EDUCATION JOB AID 4317332 KAC 30 36 48 ISLAND AND WALL CANOPY RANGE HOODS ...
Page 4: ... iv NOTES ...
Page 12: ...1 8 NOTES ...
Page 28: ......
