15
Starting Your Air Conditioner—Rotary Control—Heat/Cool Models
1. Set vent control. See “Vent Control (on some models).”
2. Select the fan speed. See “Fan Speed.”
3. Set temperature. See “Temperature.”
Vent Control (on some models)
Set the Vent control to CLOSE for maximum continuous cooling.
The Vent control set to OPEN allows you to draw stale or smoky
air from the room.
■
Open—to exhaust room air to the outside.
■
Close—to circulate room air.
NOTE: The Vent control will function only when the Fan Speed is
operating.
Fan Speed
Set Fan Speed to the desired setting. When the air conditioner is
operating at Low Heat or Turbo Heat, Turbo Cool, High Cool or
Low Cool, the fan circulates air continuously.
■
Low Heat—for reduced heating
■
Turbo Heat—for maximum heating
■
Turbo Cool—for maximum cooling
■
High Cool—for normal to maximum cooling
■
Low Cool—for sleeping comfort
■
Fan Only—to move air continuously without cooling or
heating
NOTE: Fan runs on Turbo speed only.
■
Power Saver—fan runs only when cooling or heating is
needed.
Since the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as
often. Use Power Saver when you are asleep or away from
home.
NOTE: Fan runs on Low speed only.
Temperature
Cooling
Turn the TEMPERATURE control to a setting on the right-hand
side of the knob. Adjust the air conditioner's performance by
setting the Temperature control to “1” for maximum cooling. For
less cooling, turn the TEMPERATURE control counterclockwise
to a larger number on the right-hand side of the knob.
Heating
The electric strip heater is activated when the Fan Speed control
is set to a heat setting. Turn the TEMPERATURE control to a
setting on the left-hand side of the knob. For more heating, turn
the TEMPERATURE control to “1” for maximum heating. For less
heating, turn the TEMPERATURE control clockwise to a larger
number on the left-hand side of the knob.
Experiment to find the setting that suits you best.
NOTE: Your air conditioner is not designed to be used as a
primary heat source. It is intended for supplemental heating only.
Wait three minutes before restarting
LOW
HEAT
TURBO
HEAT
TURBO
COOL
HIGH
COOL
LOW
COOL
POWER
SAVER
FAN
ONLY
OFF
F A N S P E E D
WARMER
COOLER
1
2
3
4
5
6
7
7
6
5
4
3
2
1
T E M P E R A T U R E
AIR SWING
LOW
HEAT
TURBO
HEAT
TURBO
COOL
HIGH
COOL
LOW
COOL
POWER
SAVER
FAN
ONLY
OFF
WARMER
COOLER
1
2
3
4
5
6
7
7
6
5
4
3
2
1
