11
G.
Check operation
Check that you:
✔
did not skip any steps.
✔
installed all parts.
✔
properly installed dryer legs.
✔
leveled dryer.
✔
have secured all exhaust vent joints
with 4” clamps.
✔
have all the tools you started with.
Plug power supply cord into grounded
outlet. Turn power supply on.
Read the Use and Care Guide to fully
understand your new dryer. Select a
For more information, or to
have your venting
professionally installed, call
the Consumer Assistance
Center. Check your Use and
Care Guide for a toll-free
number to call or call the
dealer from whom you
purchased this appliance. The
dealer is listed in the Yellow
Pages of your phone
directory under “Appliances
— Household — Major —
Service and Repair.”
SURE CONNECT
TM
Vent Kit
CRUSH
RESIST
ANT
Dura Safe
TM
Kits Make Installation Easy
◆
Provides 4 1/2"
clearance between
dryer and wall
◆
Snap-Lock fittings
◆
Total kit length 8 feet
◆
Additional vent can
be snapped between
sections for
longer runs
Kit Contains:
2 - 4' vent sections with attached close elbows
1 - Wall plate for close clearance installations
2 - 4" clamps
Part #4396028
Sections separate,
fittings can face
same or opposite
Extra long
band-clamp
for dryer
connection
Swivel collar
Beveled edges
allow corner
installations
Telescoping
sections
Swivel collar
wall connection
◆
Provides 2 1/2" clearance
between dryer and wall
◆
Great for closet installations
◆
0"-18", 18"-29" or 29"-50"
periscopes include one male
snap-lock fitting, one extra
long draw-band collar and
one clamp
2
1/2"
2
1
/
2
"
Periscopes For Offset
Outlets, Tight Installations
◆
Use when vent outlets
overlap or are offset
◆
Excess length can
be trimmed to fit
18"-29" and 29"-50" Periscope
0"-18" Periscope
0"-18" :
Part #4396037
18"-29" :
Part #4396011
29"-50" :
Part #4396014
Part #4396037
18"-29" : Part #4396011 29"-50" : Part #4396014
Dura Safe and Sure Connect are Trademarks of Whirlpool, U.S.A.
.
full heat cycle (not the air cycle) and
start dryer. After five minutes, open
dryer door. You should feel heat inside
dryer.
If the burner did not ignite and you do
not feel heat inside the dryer, shut the
dryer off for 5 minutes. Then check
that:
✔
controls are set in a running or
“On” position.
✔
start button has been pushed firmly.
✔
gas supply line shutoff valve is
open.
Repeat 5-minute test. If dryer still does
not operate properly, check the
following:
✔
electrical supply is connected.
✔
house fuse is intact and tight; or
circuit breaker has not tripped.
✔
dryer door is closed.
If dryer makes an unusual noise,
check that dryer is level.
