22
INSTALLATION
• Install the freezer away from heat sources. Installation in a
hot place, direct exposure to sunlight or placing it near a
heat source (radiators, cookers) will increase energy
consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must
be respected:
• 30 cm from coal or oil stoves;
• 3 cm from electric and/or gas cookers.
• Install in a dry and well-ventilated place.
• Clean the inside (see “Defrosting and cleaning the
freezer”).
• Fit the accessories supplied.
• Fit the spacers (Fig. 1, 2, or 3, depending on the model)
Electrical connection
• Electrical connections must be made in compliance
with local regulations.
• Data regarding voltage and electrical absorption are
specified on the rating plate inside the appliance.
•
Earthing of the appliance is compulsory by law
.
The Manufacturer declines any liability for injury to
persons and animals or damage due to non-
compliance with the above regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified technician.
• Do not use extension leads or multi-adapters.
Electrical disconnection
It must be possible to electrically disconnect the appliance by
unplugging it or by means of a double-pole switch installed
upstream of the socket.
Door reversibility
If required, door opening can be reversed from right to left
(depending on how it is supplied).
Caution! When reversing the door opening, the appliance
must not be connected to the power supply. The appliance
must be previously unplugged.
Tilt the appliance backwards a little and prop it in a secure
position.
Undo the door hinge screws and remove the hinge pin
bracket.
Open the door slightly and lower it.
Undo the top pin and screw it in place on the opposite side.
Insert the door on the top hinge and close it.
Tighten the hinge pin bracket in place on the opposite side
using the screws.
60202011GB.fm Page 22 Thursday, July 12, 2007 5:31 PM
