7
COOKTOP USE
Cooktop Controls
Control knobs must be pushed in before turning them to a
setting. The controls can be set anywhere between HI and “0”
(OFF).
On models with Ceramic Glass, the controls work on the principle
of percent on, percent off. When the control is turned to setting 5,
the element will be on 50% of the time.
Use the following chart as a guide when setting heat levels.
Power On Lights
The Power On lights beside the control knobs indicate which
surface elements are turned on. A Power On light will glow when
its corresponding surface element is turned on.
Elements
Quick Light Radiant Heating Elements
The quick light radiant heating elements are designed for fast
heat response. You can see them light up in just seconds. These
elements consist of a set of special heater coils embedded in a
thermal insulation material. You may notice the element going on
and off a number of times during use. This is a normal occurrence.
Simmer Element (on some models)
The simmer element is identified on the disc in the center of the
element. This element can maintain lower temperatures for
preparation of foods that require very low heat such as sauces,
chocolate or cheese.
Dual Element (on some models)
You can use the left front, dual surface element in two ways to
better match the sizes of your cookware. Use the inner area for
smaller pots that need lower wattage levels. The combination of
both inner and outer areas is for larger pots and pans that require
higher wattage levels.
The element is controlled by the “Dual / Single” control knob on
the left front of the range control panel. Push in and turn the
control knob to the desired setting in the area marked “Dual” or
“Single.”
Bridge Element (on some models)
When using extra large pots or pans, you can increase the
cooktop’s heating area and wattage by turning ON the surface
area between the front and rear elements. This “bridge” area
works in combination with the right front surface element. You
can also use the right rear element for full right-side heating.
The “bridge” and right side elements are controlled by the Dual
Switch control knob on the right front of the range control panel.
For just the right front element, push in and turn the control knob
to the “Single” setting. To turn ON the element and its adjacent
surface, push in and turn the control knob to the “Bridge” setting.
Warming Element
(on ceramic glass models)
Use the Warming Element to keep cooked foods warm. One hour
is the recommended maximum time to maintain food quality.
Do not use it to heat cold foods.
SETTING
RECOMMENDED USE
HI
■
To start foods cooking.
■
To bring liquids to a boil.
8-6
■
To hold a rapid boil.
■
To quickly brown or sear meat.
5
■
To cook gravy, pudding and sauce.
■
To fry poultry or meat.
■
To maintain a slow boil.
4-2
■
To stew or steam food.
■
To simmer food.
1
■
To keep foods warm.
■
To melt chocolate.
Simmer Element
(on some models)
■
Precise simmer control.
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
REMEMBER: When range is in use or (on some
models) during the Self-Cleaning cycle, the entire
cooktop area may become hot.
WARNING
Food Poisoning Hazard
Do not let food sit for more than one hour before
or after cooking.
Doing so can result in food poisoning or
sickness.
