GB17
When the water comes to the boil, the hob emits an acoustic signal. This signal is sounded three times at regular intervals. After the second signal, a minute minder is
automatically activated to keep track of boiling time. After the third signal, the hob automatically selects a lower power setting to keep the water simmering. From this
moment on, you can add any ingredients you like, set the timer and change the power setting. Changing the power setting or selecting the “hold” function overrides
the sixth sense function.
IMPORTANT: do not use abrasive sponges or pan scourers. as they could ruin the glass surface.
•
Clean the hob, when it is cool, after each use in order to remove any food residues.
•
Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed.
•
Salt, sugar and sand can scratch the glass surface.
•
Use a soft cloth, absorbent kitchen wipes or a specific hob cleaner (follow the Manufacturer’s instructions).
•
Read and follow the instructions given in the section “Instructions for use”.
•
Connect the hob to the electricity supply and check that the supply has not been shut off.
•
Clean the hob and dry it thoroughly.
•
If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
•
If you are unable to turn the hob off after using it, disconnect it from the power supply.
Before contacting After-sales Service
1.
See if you can eliminate the problem on your own by referring to the “Troubleshooting guide”.
2.
Switch the appliance off and then on again it to see if the problem has been eliminated.
If after the above checks the fault persists, contact the nearest After-sales Service.
Always specify:
•
a brief description of the fault;
•
the type and exact model of the hob;
•
the Service number (the number after the word Service on the rating plate) located under the appliance (on the metal plate). The Service number is also
indicated on the warranty booklet;
•
your full address;
•
your telephone number and area code.
If any repairs are required, please contact an authorised
After-Sales Service
(to guarantee that original spare parts will be used and repairs carried out correctly).
The sixth sense function is deactivated when the “hold” function is selected.
-
The hob features automatic management of the use of the sixth sense function and booster settings, therefore in some cases it may not be possible to
select the booster when the sixth sense function is already selected
-
The quality of the pot used may have a bearing on sixth sense function performance.
CLEANING
WARNING
-
Never use steam cleaners.
-
Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”) is
not displayed.
TROUBLESHOOTING GUIDE
ERROR CODE
DESCRIPTION
POSSIBLE CAUSES
REMEDY
The hob switches off and after 10 seconds
emits an acoustic signal every 30 seconds.
Continuous pressure on control panel
area.
Water or utensils on control panel.
Clean the control panel.
C81, C82, C83
The control panel switches off because
of excessively high temperatures.
The internal temperature of electronic
parts is too high.
Wait for the hob to cool down
before using it again.
F42 or F43
The connection voltage is wrong.
The sensor detects a discrepancy
between the appliance voltage and that
of the mains supply.
Disconnect the hob from the mains
and check the electrical connection.
F12, F21, F25, F36, F37, F40, F47, F56,
F58,
F60, F61, F62, F63, F64
Call the After-sales Service and specify the error code.
AFTER-SALES SERVICE
i
Attach here one of the two appliance data plate
stickers found in the warranty booklet.
31901498.book Page 17 Thursday, June 25, 2009 7:59 PM
