1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.
3. Turn the selector knob to select the
desired programme.
4. Press the Start button to start the
selected programme. The Start
indicator lamp will light up. Once set,
the programmed data cannot be
altered by turning the programme
selector knob.
Note: once the Start button has been
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds. The Start
indicator lamp will switch off. Select
a new programme and press the
Start button again.
Note: if the dishwasher is switched off
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off.
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Crockery holders:
•
Down: cups and long-stemmed
glasses.
•
Up: plates.
Lower rack
Cutlery basket (C):
•
With or without handle
(depending on model).
•
The cutlery basket can be removed
to increase available space.
C
C
How to use the dishwasher
Please read the user instructions carefully.
Upper and lower rack
