10
TROUBLESHOOTING GUIDE
1. The appliance is not working.
•Is there a power failure?
•Is the main power switch on?
•Has the fuse blown?
•Is the thermostat setting correct?
•Was the appliance switched on correctly?
2. Excessive frost build-up.
•Has the defrost water drain been positioned
correctly?
•Is the door shut properly?
3. The yellow, red and green leds do not
light up. Perform the checks for point
1, and then:
•Contact After-sales Service.
Notes:
• The front edge of the appliance may be hot.
This prevents the formation of condensation
and is not a defect.
• Gurgling and hissing noises due to
expansion in the refrigerant circuit are
normal.
AFTER-SALES SERVICE
Before contacting the After-sales Service:
1. See if you can solve the problem yourself with
the help of the Troubleshooting guide.
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
•the nature of the fault,
•the model,
•the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance),
•your full address,
•your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
The door cannot be reversed on models with
front handle.
30302005GB.fm Page 10 Tuesday, March 14, 2006 3:09 PM
