13
To Convert Surface Burners
1.
Remove grates from cooktop.
2.
Lift the cooktop by both front corners and hold it by the front
center edge.
3.
Remove the screws that hold each dual burner.
4.
Lift each burner and slip it back to remove it.
5.
Set them aside.
6.
Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Four LP gas
spuds are stamped “67.”
7.
Remove the natural gas orifice spuds from the valve using a
3/8" (9.5 mm) combination wrench.
8.
Install LP gas orifice spuds in the valves.
9.
Place the natural gas orifice spuds in the parts bag for future
use and keep with bag containing literature.
10.
Slowly lower the cooktop until it snaps into position.
11.
Replace grates.
To Convert Oven Burner
1.
Open oven door and remove oven racks, oven tray, flame
spreader and set aside.
2.
Lift oven burner. The orifice spud is behind the oven burner air
shutter.
3.
Locate LP gas orifice spud stamped “58” in literature package
supplied with range.
4.
Use a 3/8" combination wrench and remove the natural gas
orifice spud.
5.
Install the number “58” LP gas spud.
IMPORTANT:
Do not over tighten.
6.
Place natural gas oven burner spud in plastic parts bag along
with natural gas cooktop burner spuds for future use and
keep with bag containing literature.
7.
Reinstall oven burner.
8.
Reinstall oven racks, oven tray and flame spreader.
Pilot and Bypass Screws Conversion
1.
Remove control knobs and set aside.
2.
Remove upper grates.
3.
Lift the cooktop by both front corners and hold it by the front
center edge.
4.
Open oven door.
5.
Locate the two top fasteners and two bottom fasteners on the
front panel and remove them, using a Phillips head
screwdriver.
A
A. Dual burner screws
A. Air shutter
A
A
A. LP oven orifice spud stamped with “58”
B. Bottom fasteners
B
A
B
A
A. Orifice spuds
8
5
B. Valves
A. Top fasteners
