4
AIR PURIFIER CARE
Cleaning
1. Turn the fan speed knob to Off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove both filters and set aside. Do not try to wash and
reuse either the HEPA filter or the pre-filter.
5. Clean the air purifier with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
NOTE: The grille is not dishwasher safe.
7. Reassemble the filters as shown in the previous illustration.
8. Place the bottom tabs on the front grille into the slots in the
base of the air purifier. Push the top of the grille forward until
the grille locks into place.
9. Plug in air purifier or reconnect power.
10. Turn the fan speed knob to the desired fan speed.
Filter Replacement
NOTE: The filter indicator lights on top of the air purifier will glow
when it is time to replace either the pre-filter or the HEPA filter.
For the most efficient operation of the air purifier, it is
recommended that you replace the pre-filter every three months
and the HEPA filter every year. See “Replacement Filters” in the
“Assistance or Service” section.
1. Turn the fan speed knob to Off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove and replace the indicated filter. Install the new HEPA
filter in the same direction shown by the arrow located on the
filter frame. Install the new pre-filter by placing it on the tabs.
NOTE: Do not try to wash and reuse either the HEPA filter or
the pre-filter.
5. Place the bottom tabs on the front grille into the slots in the
base of the air purifier. Push the top of the grille forward until
the grille locks into place.
6. Plug in air purifier or reconnect power.
7. Turn the fan speed knob to the desired fan speed.
8. Press the Filter Reset button to turn off the filter indicator
light(s) and reset the timer.
NOTE: Pressing the Filter Reset button before either of the
filter indicator lights glows will not reset the timer.
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid
the cost of a service call...
Air purifier will not run
■
Check the following:
Is the air purifier turned on?
Is the power cord plugged into a grounded 3 prong outlet?
Has a fuse blown or has the circuit breaker tripped?
Was a regular fuse used? Use a time-delay fuse or time-delay
circuit breaker.
1. Release tabs
2. HEPA filter
3. Bottom slot
4. Pre-filter
5. Front grille
1
2
3
4
5
