5019 318 33146
AKR 801
Pre-assemble the three parts of the flue support bracket G with 4 screws. The width of the bracket must be
identical to the internal width of the telescopic flue.
Remove the perimeter extraction panel (if relevant) and the grease filter/s.
1. Mark a line on the wall right up to the ceiling, corresponding to the centre-line of the hood (1).
2. Attach the hole diagram to the wall (2). The vertical centre line printed on the hole diagram must match
the lower edge of the hood.
3. Place the support bracket over the drilling template so that it matches the outlined rectangle (3). Mark and
drill the two outside holes. Remove the drilling template. Insert two wall plugs in the holes and fix the hood
support bracket (4) in place with two 5 x 45 mm screws.
4. Fix the central bracket K with 2 screws and wall plugs above the lower bracket (see the drilling diagram for
the position of holes (5)).
5. Hang the hood on the support bracket (6). Adjust the gap (7) and the horizontal alignment (8) of the hood.
6. From inside the hood, mark a hole for the final fixing of the hood (9).
7. Remove the hood from the bracket (10), drill the hole and insert 1 wall plug (11).
8. Fit the flue support bracket G to the wall against the ceiling (Align the small slot in the bracket with the
centre-line drawn on the wall - step 1- and fix in place with two wall plugs (12).
9. Hang the hood on the bottom support bracket (13). Fix the hood to the wall with 1 screw (14) 5x45 mm
(ABSOLUTELY NECESSARY).
10. Connect an exhaust pipe (15) to the collar B, the fumes must be ducted to the outside (extractor version)
or towards the deflector (filter version). Fix the deflector (F) to the flue support bracket G.
11. Make all necessary electrical connections (16).
12. Fit the flue unit onto the extractor unit (17).
13. Fix the flue unit to the extractor unit (18).
14. Fix the flues. Warning: check that the bottom section of the flue is securely fitted onto the central bracket
(19).
15. Fix the upper section of the flue unit to the flue support bracket G with 2 screws (20).
INSTALLATION - ASSEMBLY INSTRUCTIONS
I
F
NL
E
P
GB
D
GR
31833146.fm Page 7 Monday, December 20, 2004 2:58 PM
