background image

5019 318 33259

SAFEGUARDING THE ENVIRONMENT

1. Packaging

Packaging materials are 100% recyclable and are marked with the 

recycling symbol   .Dispose of the appliance in conformity with 

local environmental regulations. Packaging materials  (plastic bags, 

polystyrene, etc.) can be dangerous for children and should be kept 

well out of their reach.

2. Product

This appliance is marked in compliance with European Directive 

2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).

By ensuring that this appliance is scrapped suitably, you can help 

prevent potentially damaging consequences for the environment and 

health. 

The symbol   on the product or the accompanying documentation 

indicates that this product should not be treated as domestic waste 

but must be taken to a suitable collection centre for the recycling of 

electrical and electronic equipment. 

Disposal must be carried out in accordance with local environmental 

regulations for waste disposal.

For further information on the treatment, recovery and recycling of 

this appliance, contact your competent local authority, the collection 

service for household waste or the shop where you purchased the 

appliance.

PRECAUTIONS AND GENERAL 

RECOMMENDATIONS

WARNING!

• The appliance is not intended for use by young children or 

persons with restricted physical, sensory or mental 

abilities or without experience and knowledge of the 

appliance, unless they are under the supervision or 

instruction of a person responsible for their safety.

Children must be supervised so that they do not play with 

the appliance.

1.

Do not connect the appliance to the electrical power supply 

until installation is completed. Always disconnect the hood 

before cleaning or carrying out maintenance by unplugging it or 

switching off the power supply.

2.

Do not “flambé” food under the hood. Naked flames could 

cause a fire.

3.

Do not leave pans unattended when frying. Cooking oil can 

catch fire.

4.

Regular cleaning and maintenance is essential to correct 

functioning and good performance. Regularly remove dirt 

deposits. Regularly clean or replace filters. Never use flammable 

materials as hoses for extracted air.

5.

If the hood is used together with other appliances powered by 

gas or other fuels, ambient negative pressure must not exceed 
4 Pa  (4  x  10

-5

 bar). For this reason, make sure the room is 

adequately ventilated.

6.

Exhaust air must not be conveyed through the same flue used by 

the heating system or other appliances powered by gas or other 

fuels.

7.

The room must be adequately ventilated when the hood is used 

together with appliances powered by gas or other fuels.

8.

When replacing the bulbs, first ensure that they are cold.

9.

The discharge air must not be ducted to a flue used for removing 

fumes produced by appliances using gas or other fuels, but must 

have a separate outlet. 

All national regulations on air discharge must be observed.

10.

The hood is not a shelf, therefore do not overload or place 

objects on it.

11.

Do not use or leave the hood without its lamps correctly 

installed - risk of electric shock.

Note:

 always wear work gloves for all installation and maintenance 

operations.

Electrical connections

The mains power supply must correspond to the voltage indicated 

on the appliance rating plate located inside the hood. If  provided 

with a plug, connect the hood to a power socket complying with 

current regulations and located in an accessible area. If it does not 

have a plug (direct connection to the power supply) or if the socket is 

not in an accessible place, fit a suitable double-pole switch that 

ensures complete disconnection from the power supply in category 

III overvoltage conditions, complying with the installation rules.

WARNING: Before reconnecting the hood circuit to the 

power supply and checking correct operation, always make 

sure the power cable is correctly fitted and that it was NOT 

crushed in its housing during installation.

Cleaning the hood

Important!

 Failure to remove oil/grease (at least once a month) 

could result in fire.

Use a soft cloth with a neutral detergent. Never use abrasive 

substances or alcohol.

Before using the hood

Please read these instructions carefully and keep them for future 

reference, in order to ensure best use of your hood. 

Packaging materials  (plastic bags, polystyrene, etc.) can be 

dangerous for children and should be kept well out of their reach.

Make sure the hood has not been damaged during transport. 

Declaration of conformity

This product has been designed, manufactured and sold in 

conformity to the following standards:

-  safety objectives of the “Low Voltage” 

Directive 2006/95/CE (which replaces 73/23/CEE and 

subsequent amendments)

- protection 

requirements 

of “EMC” Directive 89/336/EEC 

amended by Directive 93/68/EEC.

Troubleshooting guide

The hood does not work:

• Is the plug properly inserted in the power socket?

• Is there a power failure?

The hood is not extracting efficiently:

• Is the right speed selected?

• Do the filters need cleaning or replacing?

• Are the air outlets blocked?

The light does not work:

• Does the bulb need replacing?

• Is the bulb correctly fitted?

AFTER-SALES SERVICE

Before calling the After-sales Service

1.

Check to see if you can fix the problem yourself (see 

“Troubleshooting Guide”).

2.

Switch the hood off and then on again to check if the problem 

has been eliminated.

3.

If the problem persists, contact the After-sales Service.

Specify:

• the nature of the problem,

• the product model given on the dataplate inside the hood, visible 

on removing the grease filters,

• your full address,

• your telephone number and area code,

• the Service code (the number under the word SERVICE on the 

dataplate inside the hood, behind the grease filter).

If any repairs are necessary, contact an authorised Service Centre (to 

ensure the use of original spare parts and correct repair).

Failure to comply with these instructions may compromise the safety 

and quality of the product.

I

F

NL

E

P

GB

D

GR

Summary of Contents for AKR 968









Reviews: