DAILY USE
SWITCHING THE HOB ON/OFF
To use the hob turn the knob(s) clockwise and position it (them) on the
required power setting.
To turn the hob off, turn the knob(s) back to position “0”.
RESIDUAL HEAT INDICATOR
The hob is provided with 2 indicator lights showing when the cooking
zones are hot.
These indicator lights switch on as soon as the cooking zones reach a high
temperature.
These indicator lights remain on even after switching off the relevant
cooking zone and they switch off only when the temperature of the
cooking zone is no longer dangerous.
IMPORTANT:
To avoid a permanent damage the hob:
• do not use pots with bottoms that are not flat;
• do not use metal pots with enamelled bottom;
• do not place hot pots/pans over the control panel.
COOKING TABLE
KNOB
(1
−
12)
TYPE OF COOKING
1
−
2
Melting butter, chocolate, etc.
2 − 3 − 4
Keeping food warm and reheating small quantities of liquid.
4 − 5 − 6
Heating larger quantities, making custards and sauces.
6
−
7
Gentle simmering, for example: boiled vegetables, spaghetti, soups, pot
roasts, stews.
7
−
8
For all fried food, cutlets, steaks, cooking without use of lid, for example:
risotto.
8 − 9 − 10
Browning meats, roast potatoes, fried fish and to boil large quantities of
water.
11
−
12
Brisk frying, griddling steaks, etc.
MAINTENANCE AND CLEANING
Disconnect the appliance from the power supply
.
•
Do not use steam cleaning equipment.
• Do not use abrasive sponges or scouring pads as they may damage
the glass.
• After each use, clean the hob (when it is cool) to remove any deposits
and stains from food residue.
• Sugar or foods with a high sugar content can damage the hob and
must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner
(follow the Manufacturer’s instructions).
• Spills of liquid in the cooking zones can cause the pots to move or
vibrate.
• After cleaning the hob, dry thoroughly.
TROUBLESHOOTING
If the hob will not operate correctly, before calling the After-Sales Service,
refer to the Troubleshooting Guide to determine the problem.
• Read and follow the instructions given in the section “Daily use”.
• Check that the electricity supply has not been shut off.
• Turn the hob off and on again, to make sure that the problem has
been solved.
• Make sure that the knob is not turned to “0”.
Turn the multi-pole switch to “Off” for a few minutes and then turn it
back to “On”.
• The hob will not switch off: disconnect the hob immediately from the
power supply.
If after the above checks the fault still occurs, get in touch with the nearest
After Sales Service.
EN
