13
INSTALLATION
Assembly
A) If the worktop is made of wood, use the appropriate
brackets, spring clips and screws provided.
•
Position the 4 clips (A) around the cooktop frame, in the
slots provided, see Fig. 1
•
Measure the centre of the vertical sides of the cut out a
shown in Fig. 2.
•
Position the centre of the brackets (C) on the centre of the
side previously identified.
•
The upper edge of the brackets must be flush with the
worktop surface.
•
Secure using the 4 screws (B) provided that should screwed
into the pre-prepared holes.
•
Insert the cook hob into the pre-prepared hole ensuring that
the clips (A) lodge into the bracket slots provided
(C Fig. 4 e 5).
B) If the worktop is made of marble, ceramic, stone,
plastic materials, etc., order the installation kit, code
4812 310 19277 from an authorized after-sales service.
B
Fig. 2
Fig. 1
A
Fig. 3
C
Fig. 4
Fig. 5
A
31902042GB.fm Page 13 Friday, April 11, 2008 5:42 PM
