where it can transmit the signal to the unit
properly. Press once to set and press again to
cancel.
If the unit can't receive signal from the remote
control in 30 minutes, the unit will operate as
normal base on the temperature around it until it
can receive the signal from the remote control
again.
Sleep mode
Press Sleep button on remote control and the
indicator in LCD lights up, the appliance operates
in sleep mode and the fan speed is automatically
set to low speed.
NOTES:
• In Cooling mode if the current room
temperature is 26ºC or higher the set
temperature will not change when Sleep mode is
activated, otherwise, the temperature will
automatically increase 1ºC during the first hour.
• In Heating mode, the setting temperature will
automatically decrease 1ºC per hour during the
first 3 hours.
• The set temperature will not increase during the
last 7 hours in Sleep mode.
1. Press MODE to select Cooling, Dry or Heating.
NOTE: Sleep mode cannot be selected when Fan
Only is selected.
2. Press Fan button .
3. Press the
or
button to set the
temperature.
4. Press SLEEP. After 5 seconds, the lights on the
control panel display will dim.
NOTES:
• The temperature and airflow direction can be
adjusted during Sleep Mode.
• To turn off Sleep mode, press MODE, ON/OFF,
6th SENSE, JET or SLEEP again or wait 8 hours
for the air conditioner to turn off automatically.
Changing Air Direction
On Remote Control or Control Panel
Press SWING once to change vertical airflow
direction. Press again to stop airflow louver at
desired airflow direction.
Swing
Normal Sounds
When your air conditioner is operating normally,
you may hear sounds such as:
• Air movement from the fan.
• Clicks from the thermostat cycle.
• Vibrations or noise due to poor wall or window
construction.
• A high-pitched hum or pulsating noise caused by
the modern high-efficiency compressor cycling
on and off.
26
Downloaded from AC-Manual.com Manuals
