4
the event of problems, contact
the dealer or your nearest After-
sales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
Only activate the appliance
when the installation has been
completed.
This appliance is intended to be
used built-in. Do not use it
freestanding.
Carry out all cabinet cutting
works before fitting the
appliance in the furniture and
carefully remove all wood chips
and sawdust.
After installation, the bottom of
the appliance must no longer be
accessible.
Do not obstruct the minimum
gap between the worktop and
the upper edge of the oven.
Only remove the oven from its
polystyrene foam base at the
time of installation.
After unpacking the appliance,
make sure that the appliance
door closes properly.
In the event of problems,
contact the dealer or your
nearest After-sales Service.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3mm is required
and the appliance must be
earthed.
If the fitted plug is not suitable
for your socket outlet, contact a
qualified technician.
The power cable must be long
enough to connect the
appliance, once fitted in its
housing, to the main power
supply. Do not pull the power
supply cable.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
For appliances with fitted plug, if
the plug is not suitable for you
socket outlet, contact a qualified
technician.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working properly,
or if it has been damaged or
dropped. Keep the cord away
from hot surfaces.
The electrical components must
not be accessible to the user
after installation.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
The rating plate is on the front
edge of the oven (visible when
the door is open).
In case of replacement of power
cable, use only following type(s):
H05 RR-F 3 x 1.5 mm2.
It must be possible to
disconnect the appliance from
the power supply by unplugging
it if plug is accessible, or by an
accessible multi-pole switch
installed upstream of the socket
in conformity with national
electrical safety standards.
CLEANING AND
MAINTENANCE
Wear protective gloves for
cleaning and maintenance.
The appliance must be
disconnected from the power
supply before any maintenance
operation.
Never use steam cleaning
equipment.
WARNING :
It is hazardous for
anyone other than a competent
person to carry out any service
or repair operation that involves
the removal of a cover which
give protection against exposure
to microwave energy.
WARNING :
Ensure that the
appliance is switched off before
replacing the lamp to avoid
electric shock.
Failure to maintain the oven in a
clean condition could lead to
deterioration of the surface that
could adversely affect the life of
the appliance and possibly result
in a hazardous situation.
The oven shall be cleaned
regularly and any food deposits
removed.
Ensure the appliance is cooled
down before carrying out any
cleaning or maintenance.
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the door glass since
they can scratch the surface,
which may result in shattering of
the glass.
Summary of Contents for AMW 9604/IX
