5019 301 15256
Whirlpool is a registered trademark of Whirlpool USA
Connect hot and cold water supply
(Fig.1):
1. Fix one water inlet hose at the red valve
(“H”) of the washing machine and at the hot
water tap.
2. Fix the other water inlet hose at the white
valve (“C”) of the washing machine and at
the cold water tap.
To get the optimum performance you should
use both the hot and cold water supplies.
Make sure:
a) The connections are tight, but do not
overtighten by using a tool.
b) Do not invert their position
(for example: cold fill into hot inlet valve and
viceversa).
c) And see Instructions for Use “Connect the
water supply hose”.
If you wish to connect only the cold
fill (Fig. 2):
1. Fix the enclosed Y-adapter to the cold fill
tap.
2. Connect the two inlet valves on the rear of
the machine to the Y-adapter by means of
the two water inlet hoses.
Make sure all connections are tightly fixed.
The Y-adapter must not be connected to a
hot fill water tap.
Do not allow children to operate, crawl on, near or inside your washer.
Close supervision of children is necessary when the appliance is used
near them.
HOT (“H”) / COLD (“C”) FILL INSTRUCTION
Please observe that both inlet valves (red and white) of the washing
machine have to be connected to the water supply. There are two
alternative ways of doing this:
Fig. 1
Fig. 2
Cold fill
Hot fill
Cold fill
Y-adapter
White inlet valve
White inlet valve
Red inlet valve
Red inlet valve
