Whirlpool AXMT 6533 /IX, Instructions For Use Manual

GB

23

• Secure the power supply cable by fastening the

cable clamp screw then put the cover back on.

Connecting the supply cable to the electricity mains

Install a standardised plug corresponding to the
load indicated on the appliance data plate (

see

Technical data table).
The appliance must be directly connected to the
mains using an omnipolar switch with a minimum
contact opening of 3 mm installed between the
appliance and the mains.  The switch must be
suitable for the charge indicated and must comply
with current electrical regulations (the earthing wire
must not be interrupted by the switch). The supply
cable must be positioned so that it does not come
into contact with temperatures higher than 50°C at
any point.
Before connecting the appliance to the power
supply, make sure that:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated by the data
plate.

• The voltage falls between the values indicated on

the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.

 Once the appliance has been installed, the power

supply cable and the electrical socket must be
easily accessible.

 The cable must not be bent or compressed.

 The cable must be checked regularly and replaced

by authorised technicians only.

The manufacturer declines any liability should

these safety measures not be observed.

Data plate, is located inside the flap or, after the oven 
compartment has been opened, on the left-hand wall 
inside the oven.

Safety Chain

! In order 
to prevent 
accidental 
tipping of the 
appliance, for 
example by 
a child clim-
bing onto the 
oven door, the 
supplied safety 
chain MUST be 
installed! 

The cooker is fitted with a safety chain to be fixed by 
means of a screw (not supplied with the cooker) to 
the wall behind the appliance, at the same height as 
the chain is attached to the appliance.

Choose the screw and the screw anchor according 
to the type of material of the wall behind the applian-
ce. If the head of the screw has a diameter smaller 
than 9mm, a washer should be used. Concrete wall 
requires the screw of at least 8mm of diameter, and 
60mm of length. 

Ensure that the chain is fixed to the rear wall of the 
cooker and to the wall, as shown in figure, so that 
after installation it is tensioned and parallel to the 

ground level.

*

 Only available in certain models.