background image

Cabrio

Automatic Washer 

PRODUCT MODEL NUMBERS

DRAIN SYSTEM OPTIONS

WTW6700T

Electrical:

A 120-volt, 60 Hz, AC-only, 

15 or 20 amp fused electrical supply is required. 
A time-delay fuse or circuit breaker and separate
circuit are recommended.

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only.  For complete details, see Installation
Instructions packed with product.  Specifications subject to change without notice.

Ref. W10131461

10-22-07

RECESSED AREA AND CLOSET INSTALLATION

For closet installation, with a door, the minimum ventilation openings in the top and
bottom of the door are required (view B). Louvered doors with equivalent air ventilation
openings in the top and bottom are acceptable.

Standpipe drain system - wall or floor (view A & B)

The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity can be no less
than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39" (99 cm) high and
no higher than 96" (244 cm) from the bottom of the washer.

Laundry tub drain system (view C)

The laundry tub needs a minimum 
20 gal. (76 L) capacity. The top of the
laundry tub must be at least 39" (99 cm)
above the floor and no higher than 
96" (244 cm) from the bottom of the
washer.

Floor drain system (view D)

The floor drain system requires a siphon
break that may be purchased separately. 
The siphon break must be a minimum of
28" (71 cm) from the bottom of the
washer. Additional hoses might be
needed.

17"

(43.2 cm)

 1"

(2.5 cm)

 1"

(2.5 cm)

27

¹⁄₂

"

(69.9 cm)

  1"

(2.5 cm)

  27"

      (68.6 cm)

5"
(12.7 cm)

14"  max.
(35.6 cm)

      3"

(7.6 cm)

      3"

(7.6 cm)

    24 in. 
(155 cm )

2

2

    48 in. 
(310 cm )

2

2

A

B

39"

(99 cm)

Front view

B

Side view

Closet door with vents

Water:

A water heater set to deliver 120°F (49°C)

water to the washer. Hot and cold faucets located
within 3 ft (90 cm) of the hot and cold water fill
valves, and water pressure of 20-100 psi 
(138-690 kPa) for best performance. 

C

D

39"

(99 cm)

28"

(71 cm)

Reviews: