8
8.
Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE:
Do not overtighten. Damage to the coupling can result.
9.
Turn on the water faucets and check for leaks.
NOTE:
Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Connect the Drain Hose
Remove
d
rain hose from washer
d
rum
1.
Use locking pliers, squeeze hose clamp tabs together and insert
over the end of drain hose.
2.
Slide drain hose onto washer connection.
3.
Once drain hose is in place, release pliers.
4.
Washer drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub.
Laun
d
ry tu
b
d
rain or stan
d
pipe
d
rain
Connect the drain hose form to the corrugated drain hose.
A
B
A. Snap either end of the drain hose form to the drain hose at
the point where the corrugation begins.
B. Bend drain hose over drain hose form and snap into place.
To keep
d
rain water from going
b
ack into the washer:
■
Do not straighten the drain hose, and do not force excess
drain hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
■
Do not lay excess hose on the bottom of the laundry tub.
Floor
d
rain
You may need additional parts. See Floor drain under “Tools and
Parts.”
Secure the Drain Hose
1.
Drape the power cord over the washer top.
2.
Secure the drain hose to the laundry tub leg or standpipe with
the beaded strap provided. (See illustrations A and B.)
A
B
C
If the washer faucets and the drain standpipe are recessed
(see illustration C), put the hooked end of the drain hose in the
standpipe. Tightly wrap the beaded strap around the water
inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.
Level the Washer
Properly leveling your washer avoids excessive noise and
vibration.
1.
Check the levelness of the washer by placing a level on the
top edge of the washer, first side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the
front with a wood block and adjust the feet as necessary; then
prop the back and adjust feet as necessary. Repeat this step
until washer is level.
