background image

Summary of Contents for ECKMF-283

Page 1: ...AME REQUIRED STEP NUMBER l WIRING ASSEMBLY 1 315 2 WATER TUBE FI ITING 1 4 3 GRAY SEALER PERMAGUM 1 9 4 WATER INLET TUBE ALUMINUM 1 5 5 SHIELD 1 5 7 SCREWS 3 5 6 a ICE MAKER VALVE ASSEMBLY 1 6 14 15 9 ICE BUCKET 1 6 lO CLAMP 1 7 ll SCREW 4 7 10 16 12 TUBE INSERT 1 7 13 CLAMPS 2 10 14 GROMMET 1 9 15 SCREW 1 15 16 PLASTIC TUBE ASSEMBLY 1 7 17 17 COPPER TUBE ASSEMBLY 1 16 16 CLAMP 1 11 1108155 Rev A ...

Page 2: ... on back of refrigerator Install Water Tube 5n Install Clips And Shield CLIPS should stay upright unlll ICE MAKER IS in place on SHIELD Place SHIELD X5 939025 over 3 holes in side wall of freezer Attach clip X6 536533 and screw C 7 489069 through each of top 2 holes I shield Leave screws loose Slip TUBE over ReInstall INTERIOR TUBE COVER about 4 5 inches of winng assembly should be in the freezer ...

Page 3: ...o to Back Of Refrigerator to Hook HOOK UP WATER VALVE 6 Part No 627820 TO TERMINALS SC TERMINALS ARE NOT EXPOSED WATER VALVE 6 Part No 627820 CHECK BEFORE INSTALLING TO S THAT BLACK RUBBER WASHER HOOK UP COPPER TUBE ASSEMBLY 17 Part No 941593 TO WATER VALVE AND CLIP TO LEG WITH SCREW ll Part No 486645 Connect Water Line Between Water Valve At The Bottom To Inlet Tube At The Top 17 AlTACH WATER LIN...

Page 4: ...of the pipe not bottom This helps keep water away from the drill Also it keeps normal sediment from collecting in the valve WATER VALVE TUBE I Step 7 5 Fasten shutoff valve to cold water pipe with pipe clamp Be sure inlet end is solidly in the inch drilled hole in the water pipe and that washer is under the pipe clamp Tighten packing nut Tighten the pipe clamp screws carefully and evenly so washer...

Reviews: