Whirlpool FFCR70120, User Manual

EN

11

User manual

5. Add detergent

Pull out the detergent dispenser and add detergent (and 

additives / softener) into the relative compartments 

as  described  in  section  “DETERGENT  DISPENSER”. 

Observe  the  dosing  recommendations  on  the 

detergent pack.

Correct dosing of detergent / additives is important, because: 

• it

optimizes

the

cleaning

result.

• it

avoids

irritating

residues

of

surplus

detergent

in

your

laundry.

• it

saves

money

by

avoiding

waste

of

surplus

detergent.

•

it

protects

the

washing

machine

by

avoiding

calcific

a

tion

of components.

• it

respects

the

environment

by

avoiding

unnecessary

environmental burden.

6. Delaying the start of a programme

• To

set

a

programme

to

start

at

a

later

time,

see

the

section

“OPTIONS/

START

DELAY”.

7. Start programme

• Press

the

“Start/Pause”

.

The

relative

indicator

lamp

illuminates, the door locks and the “Door locked”

 indicator lights up.

•

To

avoid

overfl

o

w,

do

not

open

the

detergent

dispenser

during a running programme anymore.

• The

remaining

programme

duration

can

vary.

Factors

like unbalance in the wash load, or foam formation, can

hav

e an eff

ect on the programme duration.

8. Change the settings of a running programme, if

needed

You can still change the settings while a programme is 

running. The changes will be applied, provided the 

respective programme phase has not finished 

y

et.

To change the settings of a running programme:

• Press

“Start/Pause”

to

put

the

running

programme

on pause.

• Change

your

settings.

• Press

“Start/Pause”

again

to

continue

the

programme.

If you have changed the programme, do not add detergent 

for the new programme.

To prevent that a running programme is changed by accident 

(for instance by children), use the “Key lock”              (see section 

“FUNCTIONS”).

Pause a running programme and open the door, if 

needed

•

Press

“Start/Pause”

to

pause

a

running

programme.

• Provided

water

level

or

temperature

is

not

too

high,

the

“Door locked” indicator light turns 

off

. You can open the

door,  for  example  to  add  more  laundry,  or  to  remove

laundry which was loaded by mistake.

•

Press

“Start/Pause”

to

proceed

with

the

programme.

9. Cancelling a running programme, if needed

• Press

and

hold

the

“ON/OFF“

button

until

the

washing machine stops.

• If

the

water

level

and

temperature

are

low

enough,

the

door unlocks and may be opened.

• The

door

remains

locked

if

there

is

water

in

the

drum.

To  unlock  the  door,  switch  the  washing  machine  on,

select  the  “Spin  &  Drain”  programme  and  turn  the  spin

option off 

b

y setting the spin speed to “0“.

•

The

water

is

emptied

and

the

door

unlocks

at

the

end

of

the programme.

10. Switch off the washing machine after programme

End

• At

the

end

of

the

cycle,

the

message

“END”

is

shown

on

the display.

• The

door

can

only

be

opened

when

the

symbol

“Door

locked”        light tur

ns off

.

• Check

that

the

“Door

locked”

indicator

is

  off

,

then

open the door and take out the laundry.

• Press

“ON/OFF”

to

switch

the

washing

machine

 off

.

To  save  energy,  if  the  washing  machine  is  not  switched 

off  manually  with  the  button,  it  turns  off  automatically 

approximately 30 minutes after the end of the programme. 

Leave

the

door

ajar

to

let

the

interior

of

the

washing

machine

to dry.