9
To Adjust Oven Temperature Calibration:
1.
Make sure the oven temperature control knob is in the OFF
position. Pull oven temperature control knob straight off and
turn it over.
2.
Loosen the locking screws inside the oven temperature
control knob.
1. Locking Screws
2. Notches
3.
Adjust temperature.
To lower the temperature, hold the knob handle firmly and
turn skirt counterclockwise to move the tooth a notch to the
left.
To raise the temperature, hold the knob handle firmly and turn
the skirt clockwise to move the tooth a notch to the right.
Each notch equals about 5°F.
1. Notches
2. Tooth
3. Skirt
4.
Tighten the locking screws and replace knob.
Aluminum Foil
IMPORTANT:
Do not line the oven bottom with any type of foil,
liners or cookware because permanent damage will occur to the
oven bottom finish.
■
Do not block or cover the oven bottom vents.
■
Do not cover entire rack with foil because air must be able to
move freely for best cooking results.
■
To catch spills, place foil on rack below dish. Make sure foil is
at least 1 in. (2.5 cm) larger than the dish and that it is turned
up at the edges.
Positioning Racks and Bakeware
IMPORTANT:
Never place food or bakeware directly on the oven
door or bottom. Permanent damage will occur to the porcelain
finish
RACKS
Position racks before turning the oven on. Do not move racks
with bakeware on them. Make sure racks are level. To move a
rack, pull it out to the stop position, raise the front edge, then lift
out. Use the following illustration and chart as a guide.
BAKEWARE
To cook food evenly, hot air must be able to circulate. Allow 2 in.
(5 cm) of space around bakeware and oven walls. Use the
following chart as a guide.
1
2
1
2
3
FOOD
RACK POSITION
Frozen pies, large roasts, turkeys,
angel food cakes
1 or 2
Bundt cakes, most quick breads, yeast
breads, casseroles, meats
2
Cookies, biscuits, muffins, cakes, non
frozen pies
2 or 3
Extra large items
Extra oven rack
NUMBER OF
PAN(S)
POSITION ON RACK
1
Center of rack.
2
Side by side or slightly staggered.
3 or 4
Opposite corners on each rack. Make sure
bakeware is not directly over another.
