4-4
4.
To remove an ignition switch:
NOTE: If an ignition switch is defective, all of
the switches must be removed and replaced as
an assembly (see below).
a) Pull each switch off the gas valve.
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING AN IGNITION SWITCH & GAS VALVE
1.
Turn off the gas to the range and discon-
nect the power cord from the wall outlet.
2.
Remove all of the knobs from the control
panel by pulling them off the control shafts.
CAUTION:
When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
Ignition
Switch
Gas Valve
Gas Valve & Ignition Switches
3 Screws & Flat Washers
Control Panel
3.
To remove the control panel,
open the
oven door and remove the three screws
and flat washers from the bottom of the
control panel, then remove the panel from
the unit.
