4-7
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE DOOR LATCH & THE DOOR SWITCH
1.
Turn off the gas to the range and discon-
nect the power cord from the wall outlet.
2.
Remove the grates and burner caps from
the cooktop.
3.
Remove the burner heads, and unclip and
lift the cooktop (see page 4-2).
If you are
servicing the door latch,
remove the
cooktop from the range (see page 4-6).
4.
Remove all of the knobs from the control
panel by pulling them off the control shafts.
5.
Remove the control panel from the unit
(see page 4-4).
6.
To remove the door latch:
a) Remove the two manifold bracket
screws (see the top photo in the next
column).
CAUTION:
When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
Manifold
Bracket
(1 Screw)
Burner Box
Cover
Vent Cover
Manifold
Bracket
(1 Screw)
e) Carefully pull the right burner box side
flange out, (see the top photo), raise
the front right corner of the burner box
cover, and prop it up with a screwdriver
(see the bottom photo) so you can
access the door latch.
b) Remove the left and right burner box
flange screws (2 on each side).
c) Remove the three front burner box cover
screws.
d) Remove the two screws from the vent
cover and remove the cover.
Front Burner Box
Cover Screw
(1 of 3)
Door Latch
Prop Up Corner
Rt. Burn Box Flange Screws
Lft. Burn Box Flange Screws
Continued on the next page.
