4-13
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE OVEN LIGHT SOCKET ASSEMBLY
CAUTION:
When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
1.
Turn off the gas to the range and discon-
nect the power cord from the wall outlet.
2.
Remove the racks from inside the oven.
3.
Unscrew the lens and bulb from the oven
light socket assembly and remove them.
CAUTION:
Be careful not to scratch or chip the
oven liner paint when you remove the oven
light socket in the next step.
4.
Use a screwdriver and bend the clips on
the oven light socket away from the edges
of the liner hole, and pull the socket out of
the liner. NOTE: If it is too difficult to re-
move the socket from the front of the oven,
you will have to push the socket out from
the back of the unit.
5.
Disconnect the wires from the socket ter-
minals.
Socket Clips
Lens & Bulb
(Viewed From Rear Panel)
Socket Wires
