background image

5

6. Complete installation following instructions for your type of 

electrical connection:
4-wire (recommended)

3-wire (if 4-wire is not available)

Electrical Connection Options

4-Wire Cable from Power Supply

IMPORTANT: Use the 4-wire cable from power supply where local 
codes do not permit connecting the frame-ground conductor to 
the neutral (white) junction box wire or when connecting to a 
4-wire electrical system.

1. Connect the 2 black wires together using a UL listed wire nut.
2. Connect the 2 red wires together using a UL listed wire nut.
3. Separate the factory crimped green (or bare) and white oven 

cable wires.

4. Connect the 2 white wires together using a UL listed wire nut. 
5. Connect the green (or bare) ground wire from the oven cable 

to the green (or bare) ground wire (in the junction box) using a 
UL listed wire nut.

6. Replace junction box cover.

3-Wire Cable from Power Supply

IMPORTANT: Use the 3-wire cable from power supply where local 
codes permit connecting the frame-ground conductor to the 
neutral (white) junction box wire:

1. Connect the 2 black wires together using a UL listed wire nut.
2. Connect the 2 red wires together using a UL listed wire nut.
3. Connect the factory crimped white and green (or bare) ground 

wires of the oven cable to the white (neutral) wire in the 
junction box using a UL listed wire nut.

4. Install junction box cover.
5. Reconnect power.

Install Oven

1. Lift oven into cabinet cutout using the oven opening as an 

area to grip. 
NOTE: Push against seal area of oven front frame when 
pushing oven into cabinet. Do not push against outside 
edges.

If your home has:

And you will be 
connecting to:

Go to section:

4-wire direct

A fused 
disconnect or 
circuit breaker 
box

4-wire Cable from 
Power Supply

3-wire direct

A fused 
disconnect or 
circuit breaker 
box

3-wire Cable from 
Power Supply

A. Cable from power supply
B. Red wires

C. Green (or bare) ground wires
D. 4-wire cable from oven

E. Junction box

F. White wires

G. UL listed wire nuts

H. Black wires

I. UL listed or CSA approved 

conduit connector

(12.7 cm)

5"

1"

(12.7 cm)

3

¹⁄₂

"

(8.9 cm)

A
B

C

D

E

F

G

H

I

A. Cable from power supply
B. Junction box

C. Red wires
D. White wire (from power supply)

E. White and green (or bare) oven 

ground wires - factory crimped 

F. 4-wire cable from oven

G. Black wires
H. UL listed wire nuts

I. UL listed or CSA approved 

conduit connector

B

C

D

E

F

H

G

A

I

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven.

Failure to do so can result in back or other injury.

Summary of Contents for GSC308PRQ







Reviews: