12
Oven Lights
The oven lights are standard 40-watt appliance bulbs. They will
come on when the oven is operating in any cook mode. The oven
lights will not work during the Self-Cleaning cycle and when the
selector knob is set to OFF.
To Replace:
Before replacing, make sure the oven is off and cool.
1.
Disconnect power.
2.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3.
Turn bulb counterclockwise to remove from socket.
4.
Replace bulb and bulb cover by turning clockwise.
5.
Reconnect power.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Open oven door all the way.
2.
Flip up the hinge latch on each side.
3.
Close the oven door as far as it will shut.
4.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1.
Insert both hanger arms into the door.
2.
Open the oven door.
You should hear a “click” as the door is set into place.
3.
Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
■
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
■
Is the appliance wired properly?
See Installation Instructions.
Oven will not operate
■
Is the electronic oven control set correctly?
See “Electronic Oven Control” section.
■
On double oven models, has the correct oven been
selected?
Make sure to set the correct controls for the oven (upper or
lower) you want to use.
■
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning the other oven cannot be set
or turned on.
Cooling fan runs during baking, broiling or cleaning
■
It is normal for the fan to automatically run while the oven is in
use to cool the electronic control, and may run for up to
45 minutes after oven has been turned off.
Display shows messages
■
Is the display showing “PF”
There has been a power failure. Clear the display. See
“Display(s)” section. Set the clock, if needed. See “Clock”
section.
■
Is the display showing a letter followed by a number?
Clear the display. See “Display(s)” section. If it reappears, call
for service. See “Assistance or Service” section.
Self-Cleaning cycle will not operate
■
Is the oven door open?
Close the oven door all the way.
■
Has the function been entered?
See “Self-Cleaning Cycle” section.
■
Has a delay start Self-Clean cycle been set?
See “Self-Cleaning Cycle” section.
■
Has a delay start been set?
See “Timed Cooking” section.
■
On double oven models, is one oven self-cleaning?
When one oven is self-cleaning, the other oven cannot be set
to self-clean.
