Whirlpool ImPress LFB2611L, Manual

1.

Determine  desired  ironing  board  height
above the floor (see the Mounting Height
Chart below). NOTE: The ironing station
enclosure  will  extend  approximately  11

″

into the room.

NOTE:  The  user  can  adjust  height  of  board
after the installation with a 4

″

 differential be-

tween a maximum and minimum height. Fig-
ures under the left column are for the normal
default position.

2.

Locate the wall stud that will be used for
mounting  the  ironing  station.  The  stud
should be located as close to the center of
the cabinet as possible.

3.

Using a 3/16

″

 drill bit, predrill holes in the

upper  and  lower  cabinet  cross  braces
where the lag screws will be located.

4.

If installed, allow at least 16

″

 to the side of

the cabinet  for the door swing.

5.

Using a 3/16

″

 drill bit, predrill a pilot hole in

the  wall  stud  where  the  cabinet  will  be
attached to the wall.

6.

Attach the cabinet to the wall by inserting
the lag screws, (included with the ironing
station), through the predrilled holes in the
cabinet cross frames, or braces, and screw
them into the predrilled pilot holes in the
wall stud.

ELECTRICAL CONSIDERATIONS

All electrical work must be done in accordance
with all applicable electrical codes.

WARNING: Turn off the power at the service
entrance before wiring this unit.

Pigtails are provided behind the control panel.
Use the strain relief provided.

4

3

1

INSTALLATION INFORMATION

SURFACE MOUNTING

Desired Board Height

Mount Cabinet Above Floor

 (Inches)

(Inches)

38

30

37

29

36

28

35

27

3 4

26

33

25

32

2 4

31

23

30

22

29

21

28

20

2-1

Access Hole