7.
To remove the indicator light:
a) Cut the two indicator wires near the
case, as shown.
4-2
b) Remove the nut from the light socket
and remove the socket from the mount-
ing hole.
6.
To remove the light socket:
a) Remove the two screws from the light
lens and remove the lens, then remove
the light bulb from the socket. NOTE:
When you reinstall the light lens do not
overtighten the two screws.
Light Lens
Screw
Screw
c) Cut the socket wires at the two loca-
tions shown below.
d) Remove 1/2
″
of insulation from the cut
wire ends, and splice the light socket
wires to the wiring harness using two
twist-on wire nuts. Trim the wire
lengths, as necessary.
e) Wrap electrical tape around the wires
to hold them together.
Cut Here
Cut Here
Light Socket
Light
Socket
Nut
Twist-On
Wire Nut
Electrical
Tape
Cut 2 Indicator Wires Here
Summary of Contents for ImPress LFB2611L
