Locking Arm
Timer Knob
Timer Screws
d) Cut the timer motor wire going to the
crimp-on connector at the indicated lo-
cation shown above.
e) Splice the timer motor wire to the wir-
ing harness using a twist-on wire nut
(see steps 6d and 6e on the previous
page for the procedure).
Indicator
Light
4-3
b) Press in on the locking arms, and push
the indicator light out of the component
cover.
c) Splice the indicator light wires to the
wiring harness using two twist-on wire
nuts (see steps 6d and 6e on the pre-
vious page for the procedure).
8.
To remove the timer
:
a) Pull the knob off the timer shaft.
b) Remove the two screws and remove
the timer from the component cover.
c) Disconnect the three wires from the
timer terminals. The wires are con-
nected as follows:
Terminal 1 = cutoff switch wire
Terminal 2 = timer motor wire
Terminal 3 = AC (Black) wire
Timer
Cut Motor Wire Here
Terminals 1 2 3
Continued on the next page.
Summary of Contents for ImPress LFB2611L
