19
4.
Apply masking tape to the end of a 3/8" (1 cm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning the Natural gas broil burner orifice
hood counterclockwise to remove. The hood will be stamped
with a “155.”
5.
Replace the “155” hood with a “100” hood. Install the
propane gas broiler burner orifice hood, turning it clockwise
until snug.
IMPORTANT:
Do not overtighten.
6.
Place the broil burner on the broil burner orifice hood.
Insert the broil burner ceramic igniter in the hole in the
rear of the oven.
7.
Replace the flame spreader with all 4 tabs facing up and
the notches toward the rear of the oven.
8.
Position the broil burner against the top of the oven and
attach it with 1 screw.
9.
Replace storage drawer. See the “Remove/Replace
Drawer” section.
10.
Replace the oven door. See the “Oven Door” section.
11.
Replace the oven racks.
Complete Installation (Natural Gas to Propane Gas)
1.
Refer to the “Make Gas Connection” section for proper
connection of the range to the gas supply.
2.
Refer to the “Electronic Ignition System” section for proper
burner ignition and operation.
3.
Refer to the “Adjust Flame Height” section for burner flame
adjustments.
IMPORTANT:
You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop flame is very important. The
small inner cone should have a very distinct blue flame 1/4"
to 1/2" (6.35 mm to 1.3 cm) long. The outer cone is not as
distinct as the inner cone. propane gas flames have a slightly
yellow tip.
4.
Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
x.xx
A
A. Orifice hood
IMPORTANT:
Make sure to save the orifices that have
just been replaced in the conversion.
Natural Gas Conversion
1.
Turn the manual shut-off valve to the “closed” position.
2.
Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Propane Gas to
Natural Gas)
1.
Remove the premium storage drawer, warming drawer or
baking drawer. See the “Remove/Replace Drawer” section.
2.
Locate gas pressure regulator at rear of the drawer
compartment.
NOTE:
On models with a warming drawer or baking drawer,
an access cover must be removed to access the gas
pressure regulator.
IMPORTANT:
Do not remove the gas pressure regulator.
3.
Remove plastic cover from gas pressure regulator cap.
WARNING
T
i
p Over Hazard
A ch
i
ld or adult can t
i
p the range and be k
i
lled
.
Install ant
i
-t
i
p bracket to floor or wall per
i
nstallat
i
on
i
nstruct
i
ons
.
Sl
i
de range back so rear range foot
i
s engaged
i
n the
slot of the ant
i
-t
i
p bracket
.
Re-engage ant
i
-t
i
p bracket
i
f range
i
s moved
.
Do not operate range w
i
thout ant
i
-t
i
p bracket
i
nstalled
and engaged
.
Fa
i
lure to follow these
i
nstruct
i
ons can result
i
n death
or ser
i
ous burns to ch
i
ldren and adults
.
A
B
C
A. Gas supply line
B. Manual shut-off valve “closed” position
C. To range
A
A. Gas pressure regulator
