22
4. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak.
Correct any leak found.
Remove cooktop burner caps and grates from parts package. Align burner caps with burner base. Burner caps should be
level when properly positioned.
If burner caps are not properly positioned, surface burners will not light. Place burners, burner caps and grates on the
cooktop.
Recommendations
If the installation is not new, clean the pipes to avoid clogging the burner nozzles.
To facilitate the movement of the appliance, the installer should make a coil with the flexible copper piping and install
a shutoff valve in the supply line. The valve should be installed separate from the range and accessible for whoever
is operating the range.
Always check the tightness of the connections during installation.
If you move the range, make sure to gas pipe doesn’t get kinked or damaged.
WARNING
Fire or explosion Hazard
Always use tubes and pressure regulator components according local codes.
Check the validity of the tubes and pressure regulators and replace if necessary.
Properly tighten all gas connections during installation.
Install in accordance with specifications described in the user care and guide.
If these instructions are not followed may cause explosion, fire or damage to the physical
integrity of persons.
If the range has accessories that need a power supply, make sure the installation is close from a wall outlet.
The plug has to be connected to a power supply of 105V-140 V ~. Make sure the installation is properly grounded.
When the gas installation is done, connect the range to the electric supply.
Electrical Requirements
WARNING
Electrical Shock Hazard
Do not use an extension cord.
Don´t use the product without ground prong.
Don´t use universal plugs.
Unplug the power supply before giving maintenance.
Do not remove ground prong.
Failure to follow these instructions can result in death, fire, or electrical shock.
09-May-2014 18:21:12 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
