Whirlpool MEDB200VQ - Bravos Series 29-in Electric Dryer, Installation Instructions Manual

11

Connect remaining wires

4.

Place hooked ends of remaining direct wire cable wires  

under outer terminal block screws (hooks facing right).  

Squeeze hooked ends together and tighten screws. Finally, 

reinsert tab of terminal block cover into slot of dryer rear  

panel. Secure cover with hold-down screw. Now, go to  

"Venting Requirements".

C

B

Place hooked end of neutral wire (white 

or center) (C) of direct wire cable under 

center terminal block screw (B). Squeeze 

hooked end together. Tighten screw.

3.

Connect neutral wire

1.

Prepare to connect neutral 

     ground wire and neutral wire

B

E

A

Remove center terminal block screw (B). Remove neutral ground 

wire (E) from external ground conductor screw (A).

oPTIonAl 3-WIRE ConnECTIon

You must verify with a qualified  electrician that this grounding 

method is acceptable before connecting.

C

B

E

Connect neutral ground wire 

and neutral wire

2. 

Connect neutral ground wire (E) and neutral wire (white or 

center wire) (C) of power supply cord or cable under center 

terminal block screw (B). Tighten screw.

Connect remaining wires

3.

Place hooked ends of remaining wires under outer terminal 

block screws (hooks facing right). Tighten screws. 

A

G

Connect external ground wire

4.

Connect a separate copper ground wire (G) from the external 

ground conductor screw (A) to an adequate ground. Finally, 

reinsert tab of terminal block cover into slot of dryer rear 

panel. Secure cover with hold-down screw. Now, go to 

"Venting Requirements".