15
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on air conditioner.
2. Adjust the mode to Cool, Dry, Fan or Heat (Heat/Cool models
only).
3. For Cool or Heat (Heat/Cool models only) mode:
■
Adjust fan speed to High, Med, Low or Auto.
■
Adjust temperature between 64ºF and 90ºF (18ºC and
32ºC).
4. For Fan mode, adjust fan speed to High, Med or Low.
NOTE: In Fan mode, temperature cannot be set.
5. For Dry mode, adjust temperature up or down by 4ºF (2ºC).
6. Turn off air conditioner.
7. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
8. Press the plus or minus TEMP button to change the delay
time from 30 minutes to 24 hours.
9. After 5 seconds, Timer indicator light will remain on. Display
will show the current room temperature.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press TIMER
again. Timer indicator light will turn off.
To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press the
plus or minus TEMP button to increase or decrease the time.
3. After 5 seconds, the display will show the current room
temperature.
Using the Remote Control
NOTE: Remote control may differ in appearance.
NOTE: One CR2025 battery (included) powers the remote
control. Replace battery after 6 months of use, or when the
remote control starts to lose power.
Power
Press POWER to turn on air conditioner.
Mode
Press MODE to select Cool, Dry, Fan or Heat (Heat/Cool models
only).
6
th
Sense
™
System Control
The air conditioner automatically selects Cool or Dry mode,
depending on room temperature and sets the temperature to
79ºF (26ºC).
■
The temperature set point can be adjusted down to 75ºF
(24ºC) or up to 83ºF (28ºC). Press the up or down arrow
button once to change the temperature 2ºF (1ºC) or twice to
change it 4ºF (2ºC).
■
If the current room temperature is lower than the temperature
set point, Dry mode is selected. Fan runs on Auto speed only.
■
If the current room temperature is higher than the
temperature set point, Cool mode is selected. Fan speed may
be selected by the user.
1. Press 6
th
Sense
™
System control.
2. In Cool mode, press FAN to select High, Med, Low or Auto.
