8
Style 2 Electronic Oven Controls (on some models)
Display
When power is first supplied to the appliance, “PF” will appear on
the display. Press CANCEL or OFF/CANCEL to clear “PF” from
the display.
If “PF” appears at any other time, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
Start
The START or START/ENTER pad begins any oven function. If not
pressed within 5 seconds after pressing a function pad, the
“START?” indicator light will flash as a reminder. On some
models, “START?” will appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
Cancel or Off/Cancel
The CANCEL or OFF/CANCEL pad stops any function except the
Clock, Timer and Control Lock.
Clock
On some models, this is a 12-hour clock that shows a.m. and
p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1.
Press CLOCK.
2.
Depending on your model, press the HR or MIN or TEMP/
TIME “up” or “down” arrow pads to set the time of day. Only
on some models can the time be set to include a.m. or p.m.
3.
Press CLOCK or START.
Tones
Tones are audible signals, indicating the following:
One tone
■
Valid pad press
■
Oven is preheated (long tone)
■
Function has been entered
■
Reminder (on some models), repeating each minute after the
end-of-cycle tones
Three tones
■
Invalid pad press
Four tones
■
End of cycle
Reminder Tones (on some models):
Reminder tones may be
turned off. Press and hold STOP TIME for 5 seconds. “rEP OFF”
or “off” will appear in the display. Repeat to turn reminder tones
back on, and “rEP on” or “on” will appear in the display.
All Tones:
All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models):
Press and hold START TIME
for 5 seconds. A tone will sound and “Snd OFF” will appear on
the display. Repeat to turn tones on, and “Snd on” will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.
Tone Pitch:
The pitch is preset at high, but can be changed to
low. On some models, only the loudness of the tones can be
adjusted. On other models, the tones cannot be adjusted or
turned off.
To Change (on some models):
Press and hold BAKE for 5
seconds. A tone will sound, and “Snd LO” will appear on the
display. Repeat to change, and “Snd Hi” will appear on display.
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius on some models.
To Change:
Press and hold CUSTOM BROIL for 5 seconds. A
tone will sound, and “°C” will appear on the display. Repeat to
change back to Fahrenheit. To exit mode, press CANCEL.
Timer
The Timer can be set in hours or minutes up to 12 hours and 59
minutes, and counts down the set time. The Timer does not start
or stop the oven.
To Set:
1.
Press TIMER SET or TIMER* CANCEL. The timer indicator
light will light up on some models. If no action is taken after 5
minutes, the display will return to the time of day mode.
2.
Depending on your model, press the HR or MIN or TEMP/
TIME “up” or “down” arrow pads to set the length of time to
cook.
3.
Press START or TIMER SET. When the set time ends, end-of-
cycle tones will sound, then, if enabled, reminder tones will
sound every minute on some models.
1. Oven Display
2. Clock
3. Timer/Cancel
4. Start/Enter
(Control Lock)
5. Auto Clean
6. Off/Cancel
7. Temperature/Time
8. Cook Time
9. Start Time
10. Custom Broil
11. Bake
1
2
3 4 5
6
11
10
9
8
7
